Advertisement
Quick Links
I
Installation
Instructions
Electric Dryer
01
Questions?
Call 800.GE.CARES {800.432.2737)
or visit our Web site at: GEAppliances.com
In Canada, call 1.800.561.3344
or visit www.GEApplionces.co
I
BEFORE YOU BEGIN
Read these instructions
completely
and
carefully.
, IMPORTANT- save
these instructions
for local inspector's use.
, IMPORTANT-
Observe all governing
codes and ordinances.
, Note to Installer - Be sure to leave these
instructions with the customer.
, Note
to
Customer
Keep
these
instructions with your Owner's Manual for
future reference.
, Before the old dryer is removed from
service or discarded, remove the dryer
door.
, Service information and the wiring diagram
are located in the control console.
, Do not allow children on or in the appliance.
Close supervision of children is necessary
when the appliance is used near children.
, Install the dryer where the temperature is
above 50°F for satisfactory operation of
the dryer control system.
, Product failure due to improper installation
is not covered under the Warranty.
WARNING
RISK OF FIRE
, To reduce the risk of severe injury or death, follow all installation
instructions.
, Clothes dryer installation must be performed by a qualified installer.
, Install the clothes dryer according to these instructions
and in
accordance with local codes.
, This dryer must be exhausted to the outdoors.
, Use only rigid metal 4" diameter ductwork insidethe dryer cabinet and use
only ULapproved transition ducting between the dryer and the home duct.
, DO NOT install a clothes dryer with flexible plastic ducting materials.
If flexible metal (semi-rigid or foil-type) duct is installed, it must be
UL listed and installed in accordance with the instructions found in
"Connecting The Dryer To House Vent" on pages 4-5 of this manual.
Flexible venting materials are known to collapse, be easily crushed,
and trap lint. These conditions will obstruct dryer airflow and increase
the risk of fire.
, Do not install or store this appliance in any location where it could be
exposed to water and or weather.
, Save these instructions. (Installers: Be sure to leave these instructions
with the customer).
NOTE: Installation
and service
of this
dryer
requires
basic
mechanical
and electrical
skills.
It is your
responsibility
to
contact
a qualified
installer
to make the electrical
connections.
TOOLS YOU
WILL NEED
SLIP JOINT PLIERS
FLAT BLADE SCREWDRIVER
PHILLIPS SCREWDRIVER
MATERIALS YOUWILL NEED
4"DIA. M ETAL DUCT
(RECOMMENDED)
)
4"DIA, F LEXIBLE
METAL (SEMPRIGD)
ULLISTED
TRANSITION
DUCT
(IF NEEDED)
KITWXO8X!O077
(INCLUDES
2ELBOWS)
4"DIA, FLEXIBLE
METAL (FOIL TYPE)
ULLISTED
TRANSITION
DUCT
(IF NEEDED,)
4"DUCT
CLAMPS
(2)
OR
#'SPRING
CLAMPS
(2)
%
4"DIA, M ETAL
ELBOW
DUCT TAPE
%
EXHAUST
SAFETY
HOOD
GLASSES
GLOVES
3/4" S TRAIN
RELIEF
ULRECOGNIZED
DRYER
POWER
CORD K IT
(NOT P ROVIDED
WITH DRYER)
UL RATED
!20/240V,30A
WITH ] OR 4PRONGS,
IDENTIFY
THE PLUG
TYPE A SPER T HE
HOUSE RECEPTACLE
BEFORE
PURCHASING
LINE C ORD,
III I!11111
234D2246PO01
31-16741
i0-13
GE
Advertisement
