Advertisement
Available languages
Available languages
OPTIONS
CAN BE
WHAT IT DOES
ADDED TIME
ADDED
SELECTED
TO CYCLE
WATER
WITH
GALLONS
(LITERS)
heated dry
o
Dries dishes with heat. Use option with rinse aid to
provide best drying results. Plastic items are less
likely to deform when loaded in top rack. Turn option
off for an air dry.
Auto
Uses heating
PowerBlastTM
element to speed
drying times.
Normal
Quick
:29 to :46
CONTROL
PURPOSE
COMMENTS
Press to start o[ resume a
If the door is opened during a CYcle or power is interrupted, Start/Resume indicator
0
wash cycle
flashes. Cycle will not resume until door is closed and Start/Resume is pressed,
NOTE: If START/RESUME button is lOCated on top of d0ori PUsh door firmly CloSed
start
within 4 seconds of pressing START/RESUME. If door is not closed within 4 seconds,
resume
.
,
.
start button LED wJ fash, an audJb e tone wJ be heard (on some top contro mode s),
and cycle will not start.
Press to cancel wash cycle
Close door firmly. The dishwasher starts a 3-minute drain (if needed). Let dishwasher
©
drain completely.
F
k
J
cancel
drain
O
....
control Lock avoids
To turn on Lock press and hold CONTROL LOCK or SANITIZE (depending on model)
r_
unintended
useo{
for
3 seconds:Control
Lock !ight will stay on for a short time;indicating
that it is
.
dishwasher between cycles
activated and a ! buttons are disabled, !f you press any button while the dishwasher is
ca,ce[
orcycleand
opton changes
locked, light flashes 3times, Dishwasher door can stil be opened!closed
while
_'"
during a cycle,
controls are ocked.
c
To turn off Lock press and hold CONTROL LOCK or SANITIZE (depending on model)
for 3 s econdsl Light turns off.
NOTE:
If the model requires you to press and ho!d Sanitize to !ock controls, Control
_
Locked LED(C) will be on or off to indicate whether Control Lock is active or not,
CONTROL
PURPOSE
COMMENTS
To fo,ow theprogress Dependingonthemode , p rogress bed sp ayed bya fu,Ut d sp ay orbyan nd cator
c
of the dishwasher
light on the front panel
I_
cycle
The full iit disp!aY Wil! glow for wash (A), D_(B)'
sanitiZed or Cieanl !t will a!so showthe
estimated rernaining time for the cYCle.
O
The indicator light Will glow blue for Wash; red for dry, and green for Cyc!e complete:
Canceling
A Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely opening the door.
2.
Press CANCEL/DRAIN
button once. The Cancel/Drain light will
light up.
3.
Close the door, and the dishwasher starts a drain cycle (if
water remains in bottom of dishwasher). Let the dishwasher
drain completely. The Cancel/Drain
light turns off after
3 minutes.
Changing
A Cycle
After Dishwasher
Is Started
1. You can interrupt a cycle and restart the dishwasher from the
beginning using the following procedure.
2.
Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3.
Check that detergent dispenser cover is still closed. If cover is
open, you will need to refill the detergent dispenser before
restarting the new cycle.
4.
Press CANCEL!DRAIN
twice to reset the control.
5.
Select new cycles and options.
6.
Press START/RESUME.
Adding
A Dish After Dishwasher
Is Started
1. Check if Add a Dish indicator is lit. (Available on some models.
Otherwise, proceed to Step 2.)
2. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
3. Check whether the detergent dispenser cover is still closed. If
it is open, the wash cycle has already started and adding a
dish is not recommended.
4. If detergent has not yet been used (detergent dispenser cover
is closed), you may add a dish.
5. Press START/RESUME.
Advertisement
