Table of Contents
Advertisement
6.
6
,
Attach the Upper Handrail (122) to the Uprights (69)
with two 3" Bolts (125) and two Handrail Washers
(124). Firmly tighten the Bolts.
Make sure that all parts are properly
tightened
be-
fore you use the treadmill. Keep the included allen
wrench in a secure place. The allen wrench is used to
adjust the walking belt (see page 28). To protect the
floor or carpet from damage, place a mat under the
treadmill.
122
124
125
125
If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the receiver
and the short jumper wire included with the chest pulse sensor.
Make sure that the power cord is unplugged.
See step 6 above. Remove the two 3" Bolts (125), the two
Handrail Washers (124), and the Upper Handrail (122).
1. Remove the indicated screws from the Console Back (88).
(Important: The screws may be different lengths; re-
member which hole each screw was removed from.)
Next, remove the Console Back.
88
Screws
2. Peel the paper off the pad on the bottom of the receiver
(A). Turn the receiver so the small cylinder
is on the
side shown,
and press the receiver onto the Console
Base (81)in the indicated location.
81
,linder
3. Connect the included short jumper wire (B) to the wire on
the receiver (A). Connect the other end of the short
jumper wire to the PLS2 jack on the underside of the
Console (82). (Note: If there is already a wire in the PLS2
jack, unplug it.) Discard the other wires included with the
receiver. Use the included wire tie to secure the wires, if
needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console (82), making sure that the
screws are inserted into the same holes from which
they were removed.
See step 6. Reattach the Upper
Handrail (122).
82
PLS2
Jack
8
Advertisement
Table of Contents
