Using Your Refrigerator; Setting The Controls - Kenmore 795.70339410 Use & Care Gude

SETTING THE CONTROLS
AIRFLOW
The refrigerator control functions as the thermostat for the
entire appliance (refrigerator and freezer sections). The
colder the setting, the longer the compressor will run to
keep the temperature colder. The freezer control adjusts
the cold air flow from the freezer to the refrigerator.
Setting the freezer control to a lower temperature keeps
more cold air in the freezer compartment to make it
colder.
Cold air circulates from the freezer to the fresh food
section and back again through air vents in the wall
dividing the two sections. Be sure not to block vents while
packing your refrigerator. Doing so will restrict airflow
and may cause the refrigerator temperature to become
too warm or cause interior moisture buildup. (See air flow
diagram below.)
Temperature
0
The Refrigerator Temp Control ranges from 33 F to
O O O
46 F (0 C to 8 C). Press the Refrigerator Temp button
to cycle through the available temperature settings one
increment at a time.
The Freezer Temp Control range is from -6°F to 8°F
(=21°C to =13°C). Press the Freezer Temp button to
cycle through the available temperature settings one
increment at a time.
NOTE: When changing control settings, wait 24 hours
before making additional adjustments. The controls are
set correctly when milk or juice is as cold as you would
like and when ice cream is firm. If the temperature in
either compartment is too cold or too warm, change the
setting one increment at a time. Wait 24 hours for the
change to stabilize before adjusting again.
Dispenser
Press the Ice/Water
Select button to select
either Water, Cubed
Ice or Crushed Ice. The
selected option will
illuminate.
Some dripping may
occur after dispensing.
Hold your cup beneath
the dispenser for a
few seconds after
dispensing to catch all
of the drops.
NOTE: The dispenser will not work if any door is left open
or if the control lock is engaged.
_, CAUTION: The control display is operated by
touch. Excessive moisture on the display may cause a
malfunction. Please keep the display clean and dry.
Ultra ice
When you press the Ultra Ice button, the Ultra Ice
graphic will illuminate in the display and will continue
for 24 hours. The function will automatically shut off
after 24 hours.
You can stop this function manually by touching the
button one more time.
This function increases both ice making and freezing
capabilities.
Water FiJter Reset
CHANGE FILTER
When the water filter indicator turns on, you have
to change the water filter. After changing the water
filter, press and hold the Ultra Ice (Filter Reset) button
for three seconds to turn the indicator light off. You
need to change the water filter approximately every
six months.
18