Kenmore 795.70339410 Use & Care Gude page 16

HOW TO REPLACE THE FREEZER DRAWER
With both hands, pull out the center bar until the rail
is fully extended.
Hook the door support into the rail tabs on both sides.
Right Rail
Cover
Left Rail
Cover
With the drawer pulled out to full extension, insert the
lower basket (_ in the rail assembly.
Lower the drawer into its final position and tighten the
screws C) "
Align the tabs on the covers with the assembly holes
on each rail and snap the rail covers into place to
secure.
Assembly Hole
NOTE: Make sure that the left and right rail covers are
attached to the correct rails. See picture below.
_WARNING: If the Durabase divider is removed, there is
enough open space for children or pets to crawl inside.
To prevent accidental child and pet entrapment or
sufl:ocation risk, DO NOT allow them to touch or go
near the freezer drawer.
,_WARNING: DO NOT step or sit down on freezer
drawer.
LEVELING AND DOOR ALIGNMENT
Leveling
After installing, secure the stability of the product
with the leveling legs.
Your refrigerator has two front leveling legs--one on
the right and one on the left. Adjust legs to alter tilt
from front-to-back or side-to-side. If your refrigerator
seems unsteady or you want the doors to close
easier, adjust the refrigerator's tilt using the
instructions below:
1. Plug the refrigerator's power cord into a 3-prong
grounded outlet. Move the refrigerator into its final
position. Remove the base cover.
To remove the base cover
1) Open the Freezer Drawer. (Drawer not shown
for clarity.)
2) Once the drawer is open and there is sufficient
clearance, remove screws on the top of the
cover.
]6