Important additional soldering hints
The MMC Reader is located on the opposite of the SLIM-Lumberg connector.
Therefore the risk to damage the plastic material of this MMC-Reader is potentially high if excessive
heat is used while removal or soldering of the SLIM-Lumberg connector.
Please follow these instructions:
a) Remove the SLIM-Lumberg connector with a soldering iron and Desolder Wick
b) Clean the Pads afterwards
c) Solder the new connecter by using soldering iron under consideration of the max. allowed
temperature range.
Samples of critical area:
Lock mechanism damaged
Lock mechanism damaged
Technical Documentation
TD_Repair_L1-L3_SXG75_R1.1.pdf
Lock mechanism OK
Lock mechanism OK
Company Confidential
2005©BenQ
Release 1.1
11/2005
Page 54 of 61