Cyclonic Filter Assembly - Hoover UH72400 Owner's Manual

CYCLONIC FILTER ASSEMBLY:
How to Clean
lliiii
AWARNINGA
To reduce the risk of personal injury - Unplug
before cleaning or servicing.
Remove dirt cup as described in Fig. 4.5.
4.11 Lift the filter assembly (A) up out of the dirt cup.
4.12 Dirt and debris can be cleaned from the filter
assembly with the dusting/upholstery tool.
4.13 Place the filter assembly (A) in the dirt cup,
aligning the D-shaped tab on the top of the dirt cup.
Press down firmly to place the filter assembly back
in place. Replace dirt cup lid.
Replace dirt cup as described in Fig. 4.4.
x
BRUSHROLL: How
to Clean
A CAUTION ,&
To reduce the risk of injury from moving parts
- Unplug before servicing.
4.14 Turn vacuum over so bottom side is facing up.
Remove any debris and/or hair from brushroll.
For additional maintenance required for belt or
brushroll please contact a HOOVER ® service provider
at 1-800-944-9200.
4.15 Vacuum is equipped with an automatic
brushroll shut off in event of overload or jam.
4.16 To reset the brushroll, press the ON/OFF
Brushroll switch OFF. Then press the ON/OFF
Brushroll switch again to ON. After resetting the
brushroll may still be blocked. Check for obstructions
in the brushroll area and remove any obstructions.
12