Replacing The Internal Clock Battery - Dukane 8120WI User Manual

Replacing the internal clock battery

Installing the battery is required in some cases. (
Manual - Network Guide) A battery is not contained at the time of factory shipment.
Please replace a battery according to the following procedure.
1.
Turn the projector off, and unplug the power cord.
2.
After making sure that the projector has cooled
adequately, slowly turn over the projector, so that
the bottom is facing.
3.
Turn the battery cover fully in the direction indicated
"OPEN" using a coin or the like, and pick the cover
up to remove it..
4.
.
lightly on the battery since it may pop out of the
holder.
5.
Replace the battery with a new HITACHI MAXELL,
Part No.CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push
it into the holder until it clicks.
6.
.Replace the battery cover in place, then turn it
in the direction indicated "CLOSE" using such as
WARNING
And also improper use may result in cracking or leakage, which could result in
battery.
immediately for emergency treatment.
place.
If the leakage adheres to your body or clothes, rinse well with water immediately.
Event Scheduling in the User's
90°
20
OPEN
CLOSE
90°