Inserting Or Replacing The Internal Clock Battery - Dukane 8960WUSS User Manual

Inserting or replacing the internal clock battery

This product has an internal clock. The battery for the internal clock is not
contained at the time of factory shipment. When you use the function that requires
the internal clock (
battery according to the following procedure.
Use the following type of battery.
MAXELL, Part No. CR2032 or CR2032H
1.
Turn the projector off, and unplug the power cord.
2.
Turn the battery cover fully counterclockwise using a
coin or the like, and pick the cover up to remove it.
3.
Pry up the old
the like to take it out. Do not use any metal tools. While
may pop out of the holder.
4.
Insert the new battery or replace the battery with a new
one.
Slide the battery in under the plastic claw, and push it
into the holder until it clicks.
5.
Place the battery cover in place, then turn it clockwise
Always handle the batteries with care and use them only as
battery may explode if mistreated. Do not recharge, disassemble or dispose of
. Improper use may result in cracking or leakage, which could result
-
- Make sure the plus and minus terminals are correctly aligned when loading
a battery.
- Keep a battery away from children and pets. If swallowed consult a physician
immediately for emergency treatment.
- Do not short circuit or solder a battery.
-
place.
- If you observe battery leakage, wipe out the leakage and then
battery. If the leakage adheres to your body or clothes, rinse well with water
immediately.
- Obey the local laws on disposing a battery.
"Event Scheduling" in the Network Guide), install a new
WARNING
.
19
Battery Cover
90°
90°
directed. The
replace a