Synchronizing The Transmitter With An Ek 2000 Iem Receiver - Sennheiser SR 2000 IEM Instruction Manual

Synchronizing the transmitter with an EK 2000 IEM receiver

Network operation
using the WSM
Operation without
network
22
Synchronizing the transmitter with an EK 2000 IEM
receiver
When synchronizing your transmitter with an EK 2000 IEM receiver, please observe the
following:
Only use a transmitter and a receiver from the same frequency range (see the
type plate on the transmitter and the receiver).
Make sure that the desired frequencies are listed in the enclosed frequency infor-
mation sheet.
Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
Synchronizing the transmitter with an EK 2000 IEM receiver – individual opera-
tion
Upon delivery, transmitter and receiver are synchronized with each other. If, however, you
cannot establish a transmission link between transmitter and receiver, you have to synchro-
nize the channels of the devices:
Carry out the Easy Setup Sync
Alternatively, you can set the channel on the transmitter manually:
Make sure that you set the transmitter to the same frequency bank and the same channel
as the receiver.
Synchronizing transmitters with EK 2000 IEM receivers – multi-channel opera-
tion
In multi-channel operation, the transmitters are remote controlled via a PC running the
"Wireless Systems Manager" (WSM) software.
Advantages of controlling the transmitters via the
(WSM) software:
• Detailed overview of all transmission and receiving channels
• Remote control of all transmitters in the network
• Combination of transmitters of different frequency ranges (see page 4).
Stereo Transmitter SR 2050 IEM
Stereo Transmitter SR 2050 IEM
Connect your transmitters and your PC in a network (see page 12).
Switch your transmitters and your PC on.
Launch the "Wireless Systems
To set up your multi-channel system, proceed as described in the instruction manual of
the "Wireless Systems
Carry out the Easy Setup Sync
function (see page 16).
function and then the
Manager" (WSM) software.
Manager" (WSM) software.
function and then, for each transmission link, the
Sync function (see page 16).
"Wireless Systems
Stereo Transmitter SR 2050 IEM
Manager"
Sync