Navien NPE-180A Installation Manual page 30

Condensing water heater
Hide thumbs Also See for NPE-180A:
Table of Contents

Advertisement

Non-Direct Venting (Single Pipe)
If, at any time, the installation location could experience negative
pressure, there is a possibility of back drafting cold air through
the water heater's heat exchanger. This situation could lead to
the freezing of the heat exchanger and malfunction of the water
heater.
However, building codes in most jurisdictions disallow negative
pressures in residences. In a home with a well-balanced air supply,
the heat exchanger should not be in danger of freezing. Because
the cause of back drafting is not considered a manufacturing
problem, any freezing damage which occurs from back drafting
will not be covered by the Navien warranty. If there is any question
about the possibility of back drafting in the installation location,
use a direct venting system for the water heater.
When installed in a manufactured home (mobile home), all
combustion air must be supplied from the outdoors as described
on page 27.
When using non-direct venting, maintain non-direct vent
clearances shown on page 30 as required by ANSI Z21.10.3 and
the National Fuel Gas Code, ANSI Z223.1/NFPA 54, and CAN/
CSA B149.1 Natural Gas And Propane Installation Code.
To use non-direct venting for the water heater:
1. Insert the termination end cap into the intake air duct. Do not
glue the end cap, to allow for easy removal and cleaning of the
cap.
Vent termination cap 2"
Coupling 2"
Pipe 2"
2. Provide two openings to allow for circulation of combustion air
as specified by ANSI Z223.1/NFPA 54 or CAN/CGA B-149.1:
NPE-180A
NPE-180
Maximum Input
150,000
(BTU/H)
Outdoor
make up air
40 in
is provided, a
10" (W) x
minimum free
4" (H) or
area of 1 in
2
, per
7" round
4,000 BTU/H
Indoor make up
150 in
air is provided,
12 1/4"
a minimum free
(W) x
area of 1 in
2
per
12 1/4" (H)
1,000 BTU/H
NPE-210A
NPE-240A
NPE-210
NPE-240
180,000
199,900
2
2
2
45 in
50 in
10" (W) x
10" (W) x
5" (H) or
5" (H) or
8" round
8" round
2
180 in
2
199 in
13 1/4"
14 1/4"
(W) x
(W) x
13 1/4" (H)
14 1/4" (H)
Installing the Water Heater
2
29

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Npe-240aNpe-210a

Table of Contents