Advertisement
Installing or removing battery cartridge
.Always switch off the tool before insertion or removal of the battery cartridge.
* T o remove the battery cartridge, pull out
the
set
plate and grasp both sides of the
cartridge while withdrawing it from the
tool.
0
To install the battery cartridge, insert the
battery cartridge into the housing and
snap the set plate back into place. Be sure
to close the
set
plate fully before using
the tool.
Charging
Plug the fast charger into your power
source. Insert the battery cartridge
so
that
the plus and minus terminals on the bat-
tery cartridge are on the same sides as their
respective markings on the fast charger.
Insert the cartridge fully into the port
so
that it rests on the charger port floor.
Press the start button (red). The charging
light will come on and charging will begin.
I f the charging light does not come on,
press the reset button (yellow) first, then
button
the start button (red). If the charging light goes out within 10 seconds even after press-
ing the reset button and start button
a
couple of times, the battery cartridge is dead.
(CAUTION : Wait for more than 5 seconds after the charging light goes out to press the
reset button again.) Replace
it
with a new one. When the charging light goes out after
about one hour, you may remove the fully charged battery cartridge.
After charging, unplug the charger from the power source.
CAUTION:
0
Your new battery cartridge is not charged. You will need to charge
it
before use.
.Do not keep the button pressed in with tape, etc. or the circuit will not function pro-
perly. Also,
a
malfunction of the charger may result possibly causing overheating,
etc.
0
If you try to charge a cartridge from a just-operated tool, sometimes the charging light
will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert it
and try to charge
it
once more.
When
you
charge a new battery cartridge or
a
battery cartridge which has not been used
for a
long period,
it
may not accept
a
full charge. This is
a
normal condition and does
not indicate
a
problem. You can recharge the battery cartridge fully after discharging
it almost completely a couple of times.
0
If you wish
t o
charge
two
battery cartridges, allow 15 minutes between chargings on the
fast charger.
6
Advertisement
