Troubleshooting - Biostar iDEQ-T1 IN2940T1 Setup Manual

Troubleshooting

Probable
1. There is no power in the system.
Power LED does not shine; the fan of
the power supply does not work
2. Indicator light on keyboard does not
shine.
System is inoperative. Keyboard lights
are on, power indicator lights are lit, and
hard drives are running.
System does not boot from a hard disk
drive, but can be booted from optical
drive.
System only boots from an optical drive.
Hard disks can be read, applications can
be used, but system fails to boot from a
hard disk.
Screen message shows "Invalid
Configuration" or "CMOS Failure."
System cannot boot after user installs a
second hard drive.
iDEQ-T1 Setup Manual
Solution
1. Make sure power cable is securely
plugged in.
2. Replace cable.
3. Contact technical support.
Using even pressure on both ends of
the DIMM, press down firmly until
the module snaps into place.
1. Check cable running from disk to
disk controller board. Make sure
both ends are securely plugged in;
check the drive type in the standard
CMOS setup.
2. Backing up the hard drive is
extremely important. All hard disks
are capable of breaking down at
any time.
1. Back up data and applications files.
2. Reformat the hard drive. Re-install
applications and data using backup
disks.
Review system's equipment. Make
sure correct information is in setup.
1. Set master/slave jumpers correctly.
2. Run SETUP program and select
correct drive types. Call the drive
manufacturers for compatibility with
other drives.
42