Page 1
(318") 1314") (318") Manufacturer reserves the right t o change specifications without notice. Note: Specifications may differ from country t o country. Hammer Drill 10 mm (3/8") MODEL NHPl030 Variable Speed I Reversing No load Blows speed minute (RPM) 2,700...
SAFETY INSTRUCTIONS WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, AND PERSONAL INJURY, INCLUDING THE FOLLOWING: READ ALL INSTRUCTIONS. KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries. CONSIDER WORK AREA ENVIRONMENT.
Page 3
REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking t o keys see that and adjusting wrenches are removed from tool before turning 15. AVOID UNINTENTIONAL STARTING. Don't carry tool with finger on switch. Be sure switch is OFF when plugging in. 16.
DO NOT TOUCH ANY METAL PARTS Hold the tool by the insulated grasping surfaces t o prevent electric shock you drill into a "live" wire. Do not touch the bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin.
Page 5
Installing side grip (auxiliary handle) Screw the side grip on the tool securely Selecting action mode Rotation with hammering For drilling in concrete, granite, turn the knob that the c marking i s towards the small diamond marking. Be sure to use concrete and masonry drilling bit.
Page 6
Installing or removing drill bit CAUTION : Always be sure that the tool is switched off and unplugged before installing or removing the bit. To install the bit, place far as will go. Tighten the chuck by hand. Place the chuck key in each of the three holes and tighten clockwise.
Page 7
Reversing switch action This tool has reversing switch to change the direction of rotation. Move the revers- ing switch lever to the clockwise rotation or the counterclockwise. CAUTION Always check the direction of rotation before drilling. *Use the reversing switch only when the tool comes to direction of rotation before the tool stops may ruin the tool.
Page 8
To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. the time of hole breakthrough.
Page 9
ACCESSORIES CAUTION : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner.
MAKlTA LIMITED Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted t o be free of defects from workmanship and materials for the period of ONE YEAR from the date of original purchase. Should any trouble develop during tool, freight prepaid, to one of Makita’s Factory or Authorized Service Centers.