Table of Contents
Advertisement
Panel Descriptions
Rear Panel
1
XS-84H
6
No.
Name
1
[POWER] (main power) switch
2
AUDIO OUTPUT connectors
3
AUDIO INPUT connectors
4
Phantom power indicator
Analog video INPUT connectors
5
(RGB/COMPONENT/COMPOSITE/YC
INPUT connectors)
6
AC IN connector
7
RS-232C connector
8
LAN port
HDMI OUTPUT connectors
9
HDBaseT OUTPUT connectors
10
HDMI INPUT connectors
11
Cooling-fan exhaust port
12
2
7
8
9
Explanation
This turns the main power on and off.
When the main power has been turned on, the power button on the front panel can be used to switch
the power to on or standby.
These are 5p Euroblock connectors for output of analog audio signals. Recording units, power amps,
speakers, and other devices are connected to these.
* To make connections, use the included Euroblock plugs (p. 13).
These are 5p Euroblock connectors for input of analog audio signals. You connect audio decks,
microphones, and other such devices to these.
* To make connections, use the included Euroblock plugs (p. 13).
* AUDIO INPUT connectors 1 and 2 can supply phantom power (+48 V).
This indicator lights up when phantom power (+48 V) is turned on.
These are D-Sub 15-pin connectors for input of analog video signals. In addition to RGB signals, using
conversion cables lets you input component, composite, and Y/C (S-Video) signals. You connect video
decks, computers, and other such devices to these.
* Inputting video requires setting the type of video signal (RGB/component, composite, or Y/C) for each
input video channel.
This is for connecting the included power cord.
This is for connecting a remote-control device (such as an RS-232C-compatible computer) for operating
the unit remotely.
This is for connecting a computer or other network-capable equipment for operating the unit remotely.
These output HDMI signals. External displays or other devices equipped with HDMI input connectors are
connected to these.
* Simultaneously outputting video from both the HDMI output connector and the HDBaseT output
connector on the same channel is not possible.
These output HDBaseT signals. Projectors or other devices equipped with HDBaseT input connectors are
connected to these.
* To make connections, use a Cat 5e (Category 5e) or later shielded LAN cable.
These are for inputting HDMI signals. Video devices equipped with HDMI output connectors are
connected to these.
* Inputting video requires setting the type of video signal (HDMI) for each input video channel.
This expels internal heat to keep temperatures inside the unit from rising excessively.
NOTE
Never block the cooling-fan exhaust port. Blocking the exhaust port might result in a rise in
temperature inside the unit, resulting in malfunction due to heat.
3
4
10
5
11
Page
p. 17
p. 14
p. 14
p. 14
p. 14
p. 16
p. 28
p. 28
p. 14
p. 21
p. 15
-
Advertisement
Table of Contents
