Map Light Switch; Steering Column Adjustment - Winnebago Journey Manual

SECTION 3 –
DRIVING YOUR MOTOR HOME
• Pull end of handle toward you to switch
headlight high/low beams.
Further Information
See your chassis manual for further operating
instructions and features.

MAP LIGHT SWITCH

Driver Map Light Switch
Turn the Driver Map Light on using the panel
light brightness thumbwheel control (located on
left side of dash). Roll it upward until you feel it
click into the Map Light "On" position.
NOTE: The "Push" dial (for fog lights) are non-
functional.
Driver Map Light Switch
(Located on left side of dash)
-Typical View
Passenger Map Light Switch
Press the Passenger Map Light switch UP to
turn ON. Press switch down to turn OFF.
Passenger Map Light Switch
(Located on passenger side trim panel)
-Typical View
3-16
Further Information
Refer to the chassis manual provided in your
InfoCase for additional information on the Driver
Map Light switch.
STEERING COLUMN
ADJUSTMENT
The tilt/telescope adjustment pedal is located
on the floor to the left of the steering column as
shown.
Press pedal to adjust steering
wheel tilt or telescope
Adjust Steering Wheel or Column
Press the pedal down to adjust either the tilt or
telescope. Release the pedal when you have
adjusted the tilt angle or steering wheel distance
to your preferred position.
WARNING
Do not adjust the steering column or tilt
wheel while the vehicle is in motion. Doing
so may cause loss of vehicle control
resulting in death or personal injury.