How To Use The Needle Threader - Janome MyLock 213 Instruction Manual

Janome ML213 Instruction Manual
1, 2, 3
4
5
y
www.aaasewing.com
r
q
w
e
t

• How to Use the Needle Threader

* Turn off the power switch when you use the
Needle Threader.
* Do not use other than for the threading or
replacement of the needle.
1. Hold the stem of threader with the triangle mark
up. Guide the thread to insert it into the Y-groove
of the nib from right to left.
2. Place the V-groove over the needle just above the
needle eye. Make sure the thread does not slip
out from the Y-groove.
3. Slide the threader down along the needle while
pushing it gently until the threader pin goes into
the needle eye.
4. Push the stem so that the threader pin comes out
through the needle eye with a loop of thread.
5. Remove the threader from the needle slowly,
leaving the thread loop behind the needle eye.
Then pick the loop with the hook to pull out the
end of thread to the back.
q
Stem
w
Triangle mark
e
Y-groove
r
Thread
t
V-groove
y
Hook
Janome My Lock
ML213 Owners Manual/ User Guide
23