Recovering The Unit - Bosch DIVAR IP 3000 DIP-3040-00N Installation Manual

18 en | Recovering the unit
6 Recovering the unit
Following procedure describes how to restore the factory default image.
To restore the unit to factory default image
1.
Notice!
Make sure that a VGA monitor, a keyboard and a mouse are connected to the unit.
2.
Notice!
Do not turn off the unit during the process. This will damage the Recovery media.
3.
4.
5.
2014.11 | V5 | DOC
Start the unit and press F7 during the BIOS power-on-self-test.
The Recovery menu is displayed.
Select one of the following:
– Initial to factory image (all data will be deleted)
(restores to factory default image and deletes all data on the HDDs)
or
– Restore to Factory image (all data will not be deleted)
(restores to factory default image; data on the HDDs will not be deleted)
Note:
Windows performs the setup. The screen displays the percentage of the process.
The unit starts from the Recovery media. If the setup is successful, press Yes to restart
the system.
Windows performs the initial setup of the operating system. The unit restarts after
Windows has completed the setup.
After the restart of the unit, the factory settings are installed.
Installation Manual
DIVAR IP 3000
Bosch Sicherheitssystem GmbH