Please read and comply with conditions and must pay attention to Safety instructions these original instructions prior third parties, in particular children, when to the initial operation of your appliance and working with the appliance. store them for later use or subsequent own- The appliance may only be used by per- Risk of hearing impair- –...
The machine may not be used or stored – Symbols on the machine Symbols in the operating instruc- in hazardous areas. It is not allowed to tions use the appliance in hazardous loca- Risk of burns on account tions. Danger of hot surfaces! Allow The following applies in general: Keep –...
Operating and Functional Elements KM 130/300 R D 22 Fuse box - work station 32 Beacon lamp on/off 1 Driver cabin (optional) 23 Steering wheel 33 Horn 2 Cabin door (option) 24 Ignition lock 34 Filter dedusting 3 Tank lid...
Before Startup Start up Programme selection Fold up the cab General notes Read the operating instructions of the In order to perform different tasks, you may have to fold up the cab (optional) first. engine manufacturer before start-up Note: The cab must only be tilted while the and follow the safety instructions care- vehicle is on even ground (±...
Press accelerator pedal down slowly. When transporting in vehicles, secure Emptying waste container the appliance according to the guide- Driving method lines from slipping and tipping over. Danger The accelerator pedal can be used to – Risk of injury! When emptying the waste vary the driving speed infinitely.
Overview Safety notes regarding the batteries Maintenance intervals Please observe the following warning notes See inspection checklist 5.950-646.0! when handling batteries: Note: The elapsed-time counter shows the timing of the maintenance intervals. Observe the directions on the Maintenance by the customer battery, in the instructions for use and in the vehicle operat- Note: Where maintenance is carried out by...
Page 9
Plug in mains connector and switch on Rinse thoroughly with lots of clear water – if acid gets into the eye or comes in con- charger. Charge battery using lowest possible tact with the skin. Then consult a doctor immediately. level of charging current.
Page 10
Clean the filling area. Refill hydraulic oil. Oil grade: see Technical Data Replace and tighten the closing cap of the oil filling opening. Note If the pressure gauge shows an increased hydraulic oil pressure, the hydraulic oil filter must be replaced by Kärcher customer ser- vice.
Page 11
Fold cover forwards. Note: Installation position with blowout Adjust the side seals opening pointing down (see illustra- Check tyre pressure. tion). Drive the waste container up and se- cure it with the safety rod. Danger Risk of injury! Always apply the safety bar when the waste container is raised.
Replacing fuses EC Declaration of Conformity Open the fuse holder. We hereby declare that the machine de- scribed below complies with the relevant basic safety and health requirements of the EU Directives, both in its basic design and construction as well as in the version put into circulation by us.
Troubleshooting Fault Remedy Appliance cannot be started Sit on the driver seat, the seat contact switch gets activated. Charging or replacing battery Fill in fuel, deaerate the fuel system Change fuel filter Check fuel pipes, connections and joints and maintain them if required Inform Kärcher Customer Service.
Technical specifications KM 130/300 R D Machine data Drive speed, forward km/h Drive speed, reverse km/h Climbing capability (max.) Surface cleaning performance without side brushes 10000 Surface output with side-brush 13000 Working width without side brushes 1000 Working width with side-brush...
Page 15
Roller brush Roller brush diameter Roller brush width 1000 Speed 1/min Sweeping track Side brushes Side brush diameter Speed (continuous) 1/min 0 - 60 Tyres Size, front 15-4.5x8 Air pressure, front Size, rear 15-4.5x8 Brake Front wheels mechanical Rear wheel hydrostatic Filter and vacuum system Type...