Troubleshooting - Denon DCD-A100 Owner's Manual

ENGLISH
7
14
14
~,.R~,.I
• Connect a USB memory device
conforming to mass storage
class or MTP standards.
• This is nota malfunction. DENON
does not guarantee that all USB
memory devices will operate or
receive power.
• Connect the USB memory
device directly to the USB port.
• Set the format to FAT16 or
FAT32. For details, refer to the
USB memory device's operating
instructions.
• When divided into multiple
partitions, only files stored in the
top partition can be played.
• Record the files in a compatible
format.
• Files that are copyright protected
cannot be played on this set.
~ Cause COuntermeasu...'
• The USB memory device is
divided into multiple partitions.
• Files are stored in a non-
compatible format.
• You are attempting to playa file
that is copyright protected.
• The USB memory device is in
a format other than FAT16 or
FAT32.
• The USB memory device is
connected via USB hub.
• The set cannot recognize a USB I • Check the connection.
memory device.
• A USB memory device not
conforming to mass storage
class or MTP standards is
connected.
• A USB memory device that
the set cannot recognize is
connected.
Symptom'
When a USB
memory device
is connected.
"NO DEVICE" is
displayed.
Files on a USB
memory device
cannot be played.
Sympt~
-
i~#",'" :~.
Ca_
~j"-~
•.
COuntermeasure' ,•. ;. -
ii'.
~!ff,,""',
The iPod cannot • Cable is not properly connected. • Reconnect.
7
be played.
[USB)
symptoin '.
'~,~"'!lii:.
Cal,l"
ifF~
COuntenne..... -~ _:i:Il~-
:.""1' ...
The
set
does • The batteries are dead. • Replace the batteries with new
3
not operate ones.
properly when the • The remote control unit is too far • Move the remote control unit
4
remote control is from the set. closer to the set.
operated.
File recorded in • You have selected a copyright- • Use the <l.
[>
button on the
11
MP30rWMA protected WMA file or a file that
remote control unit to select a
formats cannot cannot be played normally.
different file.
be played.
[iPod)
Troubleshooting
If a problem occurs, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner's manual?
If this unit does not operate properly. check the items listed in the table below. If the problem persist
there may be a malfunction.
In this case. disconnect the power immediately and contact the retail outlet.
, Syn1Rt°", ,lc,
iMjl:J "
CillUU'
·'·ii',iiiAit~#i,·Count.~
••
ure
~tau.,
Disc tray does not • The power is not on. • Turn on the power. S
open.
"NO DISC" is • The disc is not properly loaded,
• Reload the disc, 3
displayed even
though a disc is
loaded.
"TRACKO OmOOs" • The loaded disc is not a CD.
• Load a CD, 3
is displayed even
though a disc is
loaded.
Playback does not • The disc is dirty or scratched. • Wipe the dirt off the disc or 3
start even when replace the disc.
the
~/Il
button is
pressed.
No sound ·The output cables are not • Check the connections.
7
is produced
properly
connected to
the
or sound is amplifier.
distorted.
• The amplifier's function setting • Check the amplifier's functions
-
or adjustments are not right. and controls and adjust as
necessary.
A specific section • The disc is dirty or scratched. • Wipe the dirt off the disc or
3
of a disc does not replace the disc.
play properly.
Programmed
• The
tracks have not been • Program properly.
10
playback is not programmed properly.
possible. • Programmed playback is not • Use a CD
10
possible with MP3 and WMA
files.
A CD-R or CD-RW • The disc has not been finalized. • Finalize the disc then play it.
2
disc cannot be • The recording conditions and/or • Use a properly recorded disc.
2
played. the quality of the disc itself are
poor.
CIl
'tl
C1l
&
,,'
~
o'
~
f
- - i
[ I
~
C)l
~.
I
to ,
CIlI
.... . .
~
C1l
Co
C"l
o
:>
:>
C1l
;l
o'
:>
V>
~
I
[General)
-<
tT
. .
" ,...
16