License Plate Lamp
Lamp Assembly
Bulb Assembly
1. Bulb Socket
2. Bulb
3. Lamp Assembly
To replace one of these bulbs:
1. Push the release tab toward the
lamp assembly.
2. Pull the lamp assembly down to
remove.
3. Turn the bulb socket (1)
counterclockwise to remove it
from the lamp assembly (3).
4. Pull the bulb (2) straight out of
the bulb socket (1).
5. Push the replacement bulb
straight into the bulb socket and
turn the bulb socket clockwise to
install it into the lamp assembly.
6. Push the lamp assembly back
into position until the release tab
locks into place.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
Replacement Bulbs
Exterior Lamp
Number
Back-up Lamp
Fog Lamp
Front Turn Signal
WY21W
Lamp (Base)
Front Turn Signal
PSY24W
Lamp (Uplevel)
Low-Beam
Headlamp (Base)
High-Beam
Headlamp (Base)
License Plate Lamp
Daytime Running
Lamp (DRL) (Base)
5W ULL
Turn Signal Lamp
Sidemarker Lamp
For replacement bulbs not listed
here, contact your dealer.
10-33
Bulb
W16W
or 921
H10
HIR2
HIR2
194
W21/
W21W
or 7440
194