Kenwood KDW45X10 Instruction Manual page 6

installation
3. If required, the worktop of the dishwasher
can be removed. The height without
the worktop is 820 mm, the minimum
dimensions required to accommodate the
dishwasher within fitted kitchen furniture
units.
Do not connect the unit to the mains before
installation. Ensure you are not installing
the unit right in front of the mains socket.
This is to avoid potential damage to the
back of the unit.
4. The condensation strip must be fitted
to the underside of the worktop above
your dishwasher to protect it against any
moisture. Its purpose is to protect your
worktop's underside from steam rising from
the dishwasher.
• Ensure the surface is clean prior to
sticking the condensation strip to the
underside of the worktop.
• Remove the backing paper from the
condensation strip.
• Stick the condensation strip to the
underside of the worktop.
Failure to attach the condensation
strip could result in damage to the
underside of your worktop!
5. The worktop can be removed by removing
the fixing screws located at the front of the
dishwasher. After removing the screws,
push the cover forward, then lift it away
from the dishwasher.
6
KDW45X10_IB_final110323.indd 6
Leave some space
Stick the Condensation Strip
under the worktop, where you
want to install the dishwasher.
Unscrew
Remove the worktop
Push forward
Step 2
Step 1
23/03/2011 3:16 PM