Adding Rinse Aid; Adjusting The Rinse Aid Reservoir - Kenwood KDW45X10 Instruction Manual

adding rinse aid

Rinse aid helps to ensure water does not cling and leave marks on crockery during the drying phase
and helps crockery dry faster after it has been washed. Only pour rinse aid that is for domestic
dishwashers into the reservoir. This model is designed to use liquid rinse aids only.
Please follow the steps below to pour the rinse aid into the storage reservoir, and the amount will
dispense automatically.
1. Turn the cap and open as indicated.
2. When the cap open marking is aligned, you
may lift the cap up.
3. Pour the rinse aid in until the level indicator
turns completely black in colour and close
the cap.
4. Be careful not to overfill the reservoir. Wipe
up any spills. The approximate volume of
the rinse aid reservoir is 110ml.
If the water hardness in your area is soft,
you may not need rinse aid as it may
cause white film to develop on your dishes.
Rinse aid warning light will illuminate when the reservoir
is running out of rinse aid and requires refilling.
Alternatively, you can judge the amount of rinse aid by checking the rinse aid indicator right next
to the reservoir's cap. When the indicator is black, it means it is full. When it is clear, it means it is
almost empty.

adjusting the rinse aid reservoir

The rinse aid reservoir has six settings. Both the recommended
setting and the factory setting is "4." If the dishes are not drying
properly or are spotted, adjust the dial to the next higher number
until your dishes are spot-free.
KDW45X10_IB_final110323.indd 15
rinse aid indicator
open
rinse aid warning light
15
23/03/2011 3:16 PM