Ford 2013 EXPEDITION Owner's Manual page 191

190 Universal Garage Door Opener (If Equipped)
If the indicator light stays on, the programming is complete. Press and
release the programmed HomeLink button, and then begin programming
your garage door opener. See below for Steps 5 – 7.
If the indicator light flashes rapidly for two seconds and then turns to a
constant light, the HomeLink button is not programmed yet. Do the
following:
Press and hold the HomeLink button while you press and release the
hand-held transmitter button every two seconds. The HomeLink
indicator light will flash slowly and then rapidly once the HomeLink
function button recognizes and accepts the hand-held transmitter's radio
frequency signal.
After programming the HomeLink button, follow Steps 5 – 7 as listed
To program additional buttons, repeat Steps 1 – 4 .
For questions or comments, please contact HomeLink® at
www.homelink.com or 1-800-355-3515.
2013 Expedition (exd)
Owners Guide gf, 3rd Printing, April 2013
USA (fus)
I n f o r ma t i o n P r o v i d e d b y :
below to program your garage door opener.
Note: You may need a ladder to reach the unit
and you may need to remove the cover or
lamp lens on your garage door opener.
5. Press the learn button on the garage door
opener motor, and then you have 30 seconds
to complete the next step.
6. Return to your car.
7. Press and hold the function button you
want to program for two seconds, then
release. Repeat this step. Depending on
your brand of garage door opener, you
may need to repeat this sequence a third
time.