Installing Stopper Plate - Makita 2106 Instruction Manual

Position the blade around the wheels and
insert the other side
of
the blade within
the
Hold the blade in place and turn the blade tightening lever counterclockwise until it hits
against the protrusion on the frame. This places proper tension on the blade. Make sure
that the blade is correctly positioned within the blade guard and around the wheels.
Start and stop the tool two or three times to make sure that the blade runs properly on
the wheels.
CAUTION :
While making sure that the blade runs on the wheels properly, keep your body away from
the blade area.
Blade guide
I T - - -
To remove the blade, follow the installation procedures in reverse.
CAUTION :
When turning the blade tightening lever clockwise to
release
the tension on the blade, the
blade may come off unexpectedly. Be careful.
Installing stopper plate (For Model 2106
only)
This tool i s shipped from the factory without the stopper plate installed. Install the
stopper plate
as
follows.
Install the stopper plate on the frame so
that the blade can run through the slot in
the stopper plate. While pressing the stopper
plate against the frame, secure the stopper
plate with the bolts using the hex wrench.
7