California Energy Commission Battery Charging Testing Instructions - AT&T CL81114 Complete User's Manual

Appendix
California Energy Commission battery charging
testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the
box. These instructions are intended for California Energy Commission (CEC) compliance
testing only. When the CEC battery charging testing mode is activated, all telephone
functions, except battery charging, will be disabled.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all
handsets are plugged with charged batteries before proceeding.
2. While you press and hold
adapter back to the power outlet.
3. After about 20 seconds, when the
The process takes up to one minute to complete. When the phone successfully
enters the CEC battery charging testing mode, the
handsets display To register HS, see manual. You hear a confirmation tone.
When the phone fails to enter this mode, repeat the steps mentioned above.
Note: The telephone base will be powered up as normal if you fail to press
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register the handsets back to the telephone base. See pages 70-71 for handset
registration instructions.
, and then press it again within two seconds.
within two seconds in Step 3.
94
, plug the telephone base power
light starts flashing, release
light turns off and all
BC