Operation; Vacuuming Dry Materials - Craftsman 125.04267621-3 evolv Operator's Manual

Operation

Vacuuming Dry Materials

!
WARNING: Be sure to read, understand and apply all the information in the
Important Safety Instructions section at the beginning of this operator's
manual. Do not vacuum in areas with flammable gases, vapors, or explosive
dusts in the air. Flammable gases or vapors include but are not limited to;
lighter fluid, solvent type cleaners, oil-base paints, gasoline, alcohol or
aerosol sprays. Explosive dusts include but are not limited to; coal,
magnesium, grain or gun powder. To reduce the risk of health hazards from
vapors or dust, do not vacuum toxic materials.
1
1
6 7
3
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. For dry vacuuming, the filter must
be installed correctly. To verify, please
refer to Installing Reusable Cloth Filter
on page 10.
3. Place the power head section back on
the collectin tank, and secure it in place
using the latches. (Fig. 4)
4. Insert the larger end of the hose into the
vacuum port on the collectin tank. Push
the required attachment onto the free
end of the hose or extension. (Fig. 5)
5. Plug the power cord into the outlet.
(Fig.6)
6. Turn the motor on by pressing the
switch to the 'I' (ON) position and begin
vacuuming. (Fig. 7)
4
7. Once you have completed vacuuming,
flip the switch to the 'O' (OFF ) position
and unplug the power cord from the outlet.
O = OFF
DO NOT USE THE CLOTH FILTER
FOR LIQUID VACUUMING.
CAUTION: Do not vacuum drywall dust,
fireplace soot or ash with standard Wet/Dry
filter. This is very fine dust which will not
be captured by the filter and may cause
damage to motor. When vacuuming fine
dust use a fine dust filter (sold separately).
7
5
I = ON