Operation; Polarized Plug; Power Switch - Craftsman CMXEVBE171550 Instruction Manual

OPERATION

WARNING:
!
To reduce the risk of fire, explosion,
or damage to Vacuum:
• Do not leave Vacuum running while
unattended - you may fail to notice import-
ant signs indicating abnormal operation such
as loss of suction, debris exiting the exhaust,
or abnormal motor noises. Immediately stop
using Vacuum if you notice these signs.
• Do not leave Vacuum plugged in when not in
use.
• Do not continue running when float has cut off
suction.
• Sparks inside the motor can ignite airborne
flammables. Do not operate Vacuum near
flammable liquids or in areas with flammable gases,
vapors, or explosive / airborne dust. Flammable
liquids, gases, and vapors include: lighter fluid,
solvent-type cleaners,
gasoline, alcohol, and aerosol sprays. Explosive
dusts include: coal, magnesium, aluminum, grain,
and gun powder.
• Do not vacuum up explosive dusts, flammable
liquids, or hot ashes.
• Do not leave sawdust or rags with stain or
polyurethane residue inside Vac. Empty drum
after picking up these potentially self-heating
materials.
WARNING:
!
To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter
motor compartment. Store indoors.
• Do not handle plug, switch, or Vacuum with wet
hands.
• Unplug Vacuum before servicing. If your Vacuum
is not working as it should, has missing parts,
has been dropped, damaged, left outdoors, or
dropped into water, call customer service at
1-888-331-4569.
• When using an extension cord, use only
outdoor-rated cords that are in good condition.
Do not allow the connection to come into contact
with liquid.
CAUTION:
!
To reduce the risk of hearing damage, wear ear
protectors when using the Vacuum for an extended
time or in a noisy area.
8
Polarized Plug (Fig. J)
To reduce the risk of electric shock, this Vacuum has a
Polarized Plug (one blade is wider than the other except
230 volt models). This Plug will fit in a Polarized Outlet
only one way. If the Plug does not fit fully in the Outlet,
reverse the Plug. If it still does not fit, contact a qualified
electrician to install the proper Outlet. Do not change the
Plug in any way.
Power Switch (Fig. J)
After you Plug the Power Cord into the Outlet, turn the Unit
on by pushing the Switch from position "O" to position "l".
The symbols used on the Switch Actuator are International
"On & Off" Symbols:
oil-based paints,
Fig. J

Power Switch

Polarized
Plug
= OFF = ON