General Setup; Blower Operation - Craftsman CMXEVCVVJF910 Instruction Manual

2. Lift the power head
9
tank .
3. Remove the contents from inside the
collection tank 9 ; make sure you have all
contents as listed on page 2.
ASSEMBLY
Caster System Assembly
4. Turn the collection tank upside down and
insert the four caster feet
on the collection tank and tighten with
14
supplied screws
feet 6 are mounted correctly. Do not over-
tighten screws. Fig. 1.
Fig. 1
GENERAL SET UP
5. Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not
installed, refer to page 6-7 for installation
instructions.
6. For wet vacuum cleaning, remove the
cartridge filter, and install the supplied foam
wet filter. See page 8 for the foam wet filter
installation instructions.
7. Place the power head back on the collection
tank and secure into place using the latches.
8. Insert the larger end of the hose
vacuum port on the collection tank
lock into place. Fig. 2.
Fig. 2
11
off the collection
6
into the slots
. Verify that the caster
15
into the
9 and
9. Choose the desired accessory
16
extension wands
of the hose 15 . Fig. 3.
Fig. 3
10. Plug the power cord into the outlet.
Turn the motor on by flipping the on/off
switch 12 to the 'I' ON position and begin
vacuuming. Fig. 4.
Fig. 4
WARNING:
COMPLETED VACUUMING, FLIP THE ON/
OFF SWITCH TO THE 'O' OFF POSITION AND
UNPLUG THE POWER CORD FROM THE
OUTLET. O = OFF

BLOWER OPERATION

This Wet/Dry Vacuum has blowing capabilities.
To use the blower feature follow the instructions
listed.
WARNING:
SAFETY GOGGLES COMPLYING WITH ANSI
Z87.1 (OR IN CANADA, CSAZ94.3) WHEN
USING BLOWER.
WARNING:
CLEAR FROM BLOWING DEBRIS.
ENGLISH
17 18
and/or
and insert onto the end
ONCE YOU HAVE
I = ON
ALWAYS WEAR
KEEP BYSTANDERS
5