Installing Or Removing Driver Bit Or Drill Bit; Switch Action; Reversing Switch Action - Makita 6221D Instruction Manual

Installing or removing driver bit or drill bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws. Place
the bit in the chuck
as
far
as
it
will go.
Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn
the sleeve counterclockwise.
Switch action
Tool speed i s increased by increasing pres-
sure on the trigger. To start the tool, simply
pull the trigger. Release the trigger t o stop.
Sleeve
CAUTION :
Before inserting the battery cartridge into the tool, always check to see that the switch
trigger actuates properly and returns to the "OFF" position when released.
Reversing switch action
This tool has a reversing switch t o change
the direction of rotation. Slide the revers-
ing switch to the left for clockwise rota-
tion or to the right for counterclockwise.
CAUTION :
0
Always check the direction of rotation before operation.
0
Move the reversing switch only after the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may damage the tool.
8