Installing Or Removing Driver Bit Or Drill Bit - Makita DHP458RM3J Instruction Manual

Empty signal for remaining
battery capacity
012714
Stop the tool and with the tool stopped press the button
on the switch panel and the remaining battery capacity
will be signaled on the panel.
The status displayed on the switch panel and the
remaining battery capacity is shown in the following
table.
LED indicator status
012023
NOTE:
Before checking the remaining battery capacity, be
•
sure to stop the tool.
1. Button
2. LED indicator
2
1
Remaining battery capacity
About 50% or more
About 20% - 50%
About less than 20%
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing side grip (auxiliary handle)
2
1
3
4
5
012711
Always use the side grip to ensure operating safety.
Insert the side grip so that the protrusions on the grip
base and steel band fit in between the grooves on the
tool barrel. Then tighten the grip by turning clockwise.
When you turn the side grip, loosen and remove the grip,
then turn the grip and insert it again.

Installing or removing driver bit or drill bit

012697
Turn the sleeve counterclockwise to open the chuck
jaws. Place the bit in the chuck as far as it will go. Turn
the sleeve clockwise to tighten the chuck. To remove the
bit, turn the sleeve counterclockwise.
Installing bit holder
1
2
012708
Fit the bit holder into the protrusion at the tool foot on
either right or left side and secure it with a screw.
When not using the driver bit, keep it in the bit holders.
Bits 45 mm long can be kept there.
8
1. Groove
2. Protrusion
3. Steel band
4. Grip base
5. Side grip
1. Sleeve
1
1. Bit holder
2. Bit