Onkyo CR-N765 Instruction Manual page 33

"Now Initializing..." appears on the display, followed by
the name of the USB flash drive.
0 Loading the USB flash drive takes about 20 to 30
seconds.
7. Press the MENU button to display the menu and use
the direction ( / ) buttons to select "Update" and
press the ENTER button.
8. Use the direction ( / ) buttons to select "CR via
USB?" and press the ENTER button.
0 This selection will not appear (and cannot be
selected) if the flash drive does not contain firmware
that can be used to update the unit.
9. Select "UpdateStart?" and press the ENTER button.
The unit firmware starts to be updated.
10. After "Completed" appears, disconnect the USB flash
drive.
11.Press the Í ON/STANDBY button on the front panel
to put the unit into standby.
0 Do not use the Í button on the remote control for
this operation.
0 If you do nothing for three minutes, the unit will
enter standby automatically.
The update is complete. The unit's firmware has been
updated to the latest version.
When an error message appears
When an error occurs, "Error!! *-**" or an error message
appears on the display of this unit. (Letters and numbers
appear in place of the asterisks.) Refer to the descriptions
below to check the meaning.
Error code
*-10, *-20: The USB flash drive could not be
recognized. Confirm that the USB flash drive is
securely connected to the USB port on the front of the
unit.
*-14: The root folder of the USB flash drive does not
contain a firmware file or the firmware file is for a
different model, for example.
Others: Disconnect and reconnect the power cord,
and retry updating.
Various settings
33