Operating Instructions - Fetco CBS-2031ee User Manual

Control Panel Functions
Only switches that are active are illuminated.
Switches that are inactive or disabled are invisible.
Power Switch
Turns brewer on and off.
To turn on, press and hold briefly
until display reads S t b.
Display
"FILL" = Water tank is filling.
"LO XXX" = Unit is heating, not
ready to brew. (XXX = actual
temperature.)
Blank = Ready to brew.
Also displays error messages.
Stop Switches
Stops brew cycle
Lit = Brew cycle in progress
Invisible = Not brewing, or dripping
in progress
Brew Switches
Starts brew cycle
Must be held in for 1 second
Flashing = Brew cycle in progress
Lit = Ready to brew
Invisible – Not ready to brew, or
batch disabled
(See Programming Section)
Power Indicator Lamp
The lamp is lit whenever the unit is
connected to a power source.
Brewing
1. Turn the power switch on.
2. Prepare a brew basket with the correct size
filter and appropriate amount of coffee.
3. Slide the brew basket completely into the
rails.
4. Place a clean, empty, preheated dispenser
under the brew basket.
5. Select a batch from the available choices,
and hold the corresponding BREW button in
for 1 second to start the brew cycle.
6. The STOP button will illuminate, and the
selected BREW button will flash, indicating
that brewing is in progress. All other BREW
buttons will extinguish.

Operating Instructions

8
7. When the brew cycle is finished, the STOP
button will extinguish and the BREW button will
continue to flash for the amount of time
programmed into the drip delay setting. This
indicates that coffee may still be dripping from
the bottom of the brew basket.
8. Before removing the brew basket or dispenser,
visually verify that dripping has stopped.
Notes:
Preheat dispenser by filling at least ½ full with
water at brewing temperature. Allow it to sit for
at least 15 minutes before draining.