Ford 2016 TRANSIT Owner's Manual page 134

How to Start Operator Commanded
Regeneration
WARNING
Stay clear of exhaust tip during
regeneration. You or others can be
burned.
Note: You cannot use the operator
commanded regeneration until the diesel
particulate filter load percentage has
reached 100 percent. The diesel particulate
filter load percentage will fluctuate up and
down when driving your vehicle due to active
and passive regenerations.
To start operator commanded regeneration, run the engine at normal operating
temperature and scroll to:
Message
Settings
Exhaust Filter
Full
OK = Cleaning
Select one of the following:
Exhaust Filter
Full
Exhaust Filter
Overloaded
Transit (TTH) Canada/United States of America, enUSA, First Printing
Fuel and Refueling
Note: During the use of operator
commanded regeneration, you may observe
a light amount of white smoke. This is
normal.
illuminated.
Using the Information Display
You can start operator commanded
regeneration using the information display.
See (page 82).
Action and Description
Press the OK button.
Press the OK button.
Press the OK button and then follow the prompts regarding
exhaust position as needed to initiate operator commanded
regeneration. Be sure to understand each prompt. If you are
not sure what is being asked by each prompt, contact an
authorized dealer. The display will confirm the operation has
started and when it has finished.
Press the OK button and then follow the prompts regarding
exhaust position as needed to initiate operator commanded
regeneration. Be sure to understand each prompt. If you are
not sure what is being asked by each prompt, contact an
authorized dealer. The display will confirm the operation has
started and when it has finished.
131
You cannot use the operator
commanded regeneration if the
service engine soon light is