Steering Adjustment - Yamaha YW50AP Service Manual

STEERING ADJUSTMENT

5
4
3
2
1
3-18
STEERING ADJUSTMENT
1. Check:
8 Steering assembly bearings
Gap the bottom of the forks and gently
rock the fork assembly back and forth.
Loosen→Adjust.
***************************************
Adjustment steps:
8 Remove upper cover, lower cowling, leg
shield 1,2. refer to "COVER AND PANEL" sec-
tion.
8 Remove all ringnuts using ringnut wrench.
Ring nut wrench:
YU-33975
8 Tighten the ring nut 3 1 using nut wrench.
22 Nm(2.2 m.kg, 16 ft.lb)
NOTE:
Set the torque wrench to the ring nut wrench
so that they form a right angle.
8 Loosen the ring nut 3 1 1/4 turn.
8 Install rubber ring 2 and ring nut 2 3, then
tighten the ring nut 2 until it contacts with
rubber ring.
cC
Aligning the slot of ring nut 2 with the slot of
ring nut 3. If not, slightly tighten ring nut 2 un-
til the slots alignment.
8 Install special washer 4
NOTE:
Insert the projections of special washer into the
slots of ring nut 3, 2
8 Install ring nut 1 5
8 Move the handlebar up and down, and/or
back and forth. If handlebar play is excess,
remove the front fork assembly and check
the balls/ball races. Refer to chapter 6.
***************************************
INSP
ADJ
66Nm(6.6 m.kg, 47.8 ft.lb)