Solid State Drives (Ssd); Ssd Installation Guidelines; Shutdown Procedure For Servicing An Ssd; Removing An Ssd From An Ssd Carrier - Dell PowerEdge FC430 Owner's Manual

NOTE: You must remove the processor-and-DIMM blank when using a dual processor
configuration or to service other components inside the system.
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove the cooling shroud.
Steps
1. Align the standoffs on the processor-and-DIMM blank with the heat sink retention screws on the
system board.
2. Press the processor-and-DIMM blank onto the system until it engages with the DIMM sockets on the
system board.
Next steps
1. Ensure that you install a processor-and-DIMM blank when you have removed a processor
permanently.
2. Install the cooling shroud.
3. Follow the procedure listed in
Related Links
Removing the cooling shroud
Installing the cooling shroud

Solid State Drives (SSD)

The PowerEdge FC430 supports one or two 1.8 inch uSATA SSDs. The SSDs are supplied in special hot
swap drive carriers that fit in the drive bays and these drives connect to the system board through the
SSD backplane board.

SSD installation guidelines

In a dual SSD bay sled that has a single SSD installed, an SSD blank must be installed in the vacant drive
bay to maintain proper airflow.

Shutdown procedure for servicing an SSD

NOTE: This section applies only to situations where the sled must be powered down to service an
SSD.
If you need to service an SSD, turn off the sled and before removing the SSD wait for 30 seconds after the
sled's indicator turns off. Otherwise, the SSD may not be recognized after it is reinstalled and the sled is
powered on again.

Removing an SSD from an SSD carrier

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Safety instructions.
Before working inside your
After working inside your
system.
system.
69