The Timer; Panel Lock; Automatic Time Limitation; Basic Settings - Bosch NIT5066UC Use And Care Manual

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off an element.
Setting the kitchen timer
Touch the Timer key until the
1.
kitchen timer. appears on the timer display.
‹‹
Touch the or key. The basic settings are
@ A
2.
displayed.
key = 10 minutes
@
A key = 05 minutes
Program the desired time using the
3.
The timer start to count down after a few seconds.
Changing or cancelling the kitchen timer
Touch the Timer key repeatedly until the
lights up over kitchen timer. Adjust the time using the
or key. To cancel set the timer to
A
Once the time has elapsed
A beep sounds. The timer display shows
indicators lights up over kitchen timer. Touch the
Ú
Timer key. The indicator goes out and the beep stops.

Basic settings

The appliance has various basic settings. You can adjust
these settings to the way you usually cook.
Display Function
Automatic child lock/panel lock
™‚
Off*
‹
On
‚
™ƒ Audible signals
Confirmation signal and error signals deactivated
‹
Only error signals activated
‚
Only confirmation signals activated
ƒ
All signals activated*
„
Automatic timer
™†
Off*
‹
‚ - ŠŠ
14
Ú indicator lights up over
or key.
@ A
Ú indicator
.
‹‹
and the
‹‹
Automatic shut-off time

Panel lock

You can use the child safety panel lock to prevent
children from accidentally turning the cooktop on.
Turning the panel lock on
The cooktop must be turned off.
Touch Panel Lock for 4 seconds. The
Panel Lock lights up for 10 seconds. The cooktop is now
locked.
Turning the panel lock off
Touch Panel Lock for 4 seconds. The child lock is now
deactivated.
CAUTION
9
The child lock may be accidentally turned on and off
due to:
water spilled during cleaning
@
▯
food that has overflowed
▯
objects being placed on the Panel Lock key.
▯
Automatic panel lock
With this function, the panel lock is automatically
activated whenever you turn off the cooktop.
Turning on and off
See "Basic settings" section.

Automatic time limitation

If the element is used for prolonged periods of time
without changes in the settings being made, the
automatic time limitation function is triggered.
The element stops heating.
indicator / flash alternately in the display.
• œ
The indicator goes out when any symbol is pressed. The
element can now be reset.
When the automatic time limitation is activated depends
on the selected heat level (from 1 to 10 hours).
indicator over
Ú
and the residual heat
"‰