Stihl FS 260 C Instruction Manual page 31

Attaching machine to harness
2
1
2
Attach the carabiner (1) to the
N
carrying ring (2) on the shaft.
Balance the machine – see
N
"Balancing the Machine".
Disconnecting machine from harness
1
2
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
FS 260 C, FS 360 C
FS 360
Putting on the harness
1
1
2
Put on the full harness (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attach the spring hook to the
N
machine's perforated rail (3).
Find the right attachment point for
N
the cutting attachment you are
using – see "Balancing the
Machine".
Attaching machine to harness
1
N
Disconnecting machine from harness
2
3
N
Throwing Off the Machine
The machine must be quickly thrown off
in the event of imminent danger. To
throw off the machine, use the
procedure described under "Detaching
Machine from Harness". Practice
removing and putting down the machine
as you would in an emergency. To avoid
damage, do not throw the power tool to
the ground when practicing.
2
1
2
Attach the carabiner (1) to the
perforated rail (2) on the drive tube.
1
2
Press down the bar on the
carabiner (1) and pull the perforated
rail (2) out of the carabiner.
WARNING
English
1
1
2
29