Stihl FS 260 C Instruction Manual page 28

English
1
2
3
Remove the guard washer (1) and
N
thrust plate (2).
Remove the guard ring (3) for
N
mowing attachments.
Keep the guard washer and guard
N
ring in a safe place for future use.
2
4
Fit the guard ring (4) for saw blades.
N
Slip the thrust plate (2) over the
N
shaft.
Fit the limit stop (5) for circular saw
N
blades.
NOTICE
Do not use the guard washer (1) with
circular saw blades.
26
Check direction of rotation of cutting
attachment
Cutting edges of circular saw blades
must point clockwise.
4
5
2
b
a
Place the cutting attachment (1) in
N
position.
WARNING
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Securing the cutting attachment
N
N
A rider plate (3) for sawing applications
is available as a special accessory. It
allows the full depth of cut of the saw
blade to be used.
N
N
If the mounting nut has become too
loose, fit a new one.
3
NOTICE
1 Remove the tool used to block the shaft.
Removing the cutting attachment
N
N
N
Fit the thrust washer (2) – convex
side must face up.
Fit the rider plate (3).
Block the shaft.
Fit the nut (4) counterclockwise and
tighten it down firmly.
WARNING
Block the shaft.
Unscrew the mounting nut
clockwise.
Pull the cutting attachment with its
mounting hardware off the gearbox.
FS 260 C, FS 360 C