Stihl FS 260 C Instruction Manual page 21

5
6
2
7
Line up control handle (5) in relation
N
to handlebar (2): Throttle trigger (6)
must point toward the gearbox and
the clamp screw (7) toward the
engine.
FS 260 C, FS 360 C
8
2
5
4
8
Holding the control handle (5) in
N
that position, push it on to the end of
the handlebar (2) and line up the
holes (8).
Fit the nut (4) in the control
N
handle (5), insert the screw (3) and
tighten it down firmly.
Assembling the Handle Support
To assemble the swivelling handle
support it is necessary to fit a spring in
the clamps and secure them to the
handle support on the machine.
Use the spring (9) from the parts kit
N
supplied with the machine.
Place the spring (9) in the lower
N
clamp molding (10).
3
1
2
Position the clamp moldings (1) with
N
handlebar (2) on the handle
support (11).
English
9
10
A
11
19