Rockhopper II - User's Guide
4.4 Menu setup on the operation panel
This section describes how to make the Menu settings on the operation panel, and setup items.
Follow the steps below to make the Menu settings.
1. Make sure that the operation panel is normal.
2. Press the [MENU
•The screen shows the Menu.
3. Perform setting of various setup menu by following the below items.
4.4.1 Setup menu-
TIP
•
For functions of the operation panel when the setup menu is displayed, refer to the followings.
•
2.3.3 Operation panel
•
2.4.2 Setting menu display
•
For the structure of the setup menu, refer to the followings.
•
Setup menu structure
•
When page numbers of the setup menu is displayed on the operation panel, display sequence can be changed by
pushing [MENU
] key or [MENU
•
< >in each table shows the parameters set at the factory (initial settings)
4.4.1 Setup menu
This section describes each setup menu of the printer.
] key or [MENU
] key on the operation panel.
4.4.87 Tank change menu
] key.
4-7
4 Handling the printer