Menu Setup On The Operation Panel - MUTOH Rockhopper II Series User Manual

5.4. MENU SETUP ON THE OPERATION PANEL

This section describes how to make the Menu settings on the operation panel, and setup items.
Follow the steps below to make the Menu settings.
Step 1 :
Make sure that the operation panel is normal.
Step 2 : Press the [MENU ↑] or [MENU ↓] key.
The screen shows following Menu.
Current Setup Menu → * SetupMenu *
Step 3 :
Set the setup menu as follows :
Refer to 'Setup menu' – 'Tank change menu'
Notes :
•
•
•
•
Plot OK
Heaters
Cut&Feed
User1
F1 → Ink Status
F3 → TestPrint
For functions of the operation panel with the setup menu displayed, refer to the
following :
Operation panel
o
Setting menu display
o
For the structure of the setup menu, refer to the following :
Setup menu structure
o
When page numbers of the setup menu are displayed on the operation panel, you can
change the sequence by pressing the [MENU ↑] or [MENU ↓] key.
Each table shows the factory default settings.
Rockhopper II series printers – User's Guide
Cleaning
Lever Up
xxxm
OriginSet ← F2
MediaSet ← F4
(1/7)
77 AP-75095, Rev. 2.0, 24/10/03