Table of Contents
Advertisement
4 Configuration
From Port/To Port: Specifies the PoE function of a port or ports.
State: Select "Enabled" or "Disabled" to configure PoE function for designated port(s). Default is Enabled.
Time Range: Select the PoE time profile configured from Time-Based PoE > Time Range Settings to enable
the time-based PoE function on designated port(s). Default setting is N/A.
Priority: Configure the power supply priority as "Low", "Normal", or "High" on designated port(s). Default is
Normal.
Delay Power Detect: Configure the delay power detection. Default is Disabled.
Power Limit: This function allows you to manually set the port power current limitation to be given to the PD.
To protect the DGS-1210 PoE series and the connected devices, the power limit function will disable the PoE
function of the port when the power is overloaded. Select from "Class 1", "Class 2", "Class 3", "Class 4"
and "Auto" for the power limit. "Auto" will negotiate and follow the classification from the PD power current
based on the 802.3at standard.
User Define: Check the box and input the power budget (from 1 to 30W) to manually assign an upper limit of
port power budget on designated port(s).
Click Apply to make the configurations take effects or click Refresh to redisplay the table.
Note: This switch conforms to IEEE 802.3af and 802.3at standards. The IEEE
PoE standard requires a switch to shut off power to a port if the power draw is
less than 10mA within a 400ms time interval. To support some non-standard
devices that may take longer, you may enable this feature to extend the time
interval to 500ms. If the PD is still not powering on, please contact the vendor
of your device for support.
Figure 4.115 – PoE > PoE Port Setting
Note: For the PoE Port Settings table, if the
classification was shown as "Legacy PD", it will be
classified to non-AF PD or Legacy PD.
8
8
3
3
D-Link Web Smart Switch User Manual
Advertisement
Table of Contents
