Table of Contents
Advertisement
4 Configuration
D-Link Web Smart Switch User Manual
Figure 4.100 - Add Access Rule – IPv4 ICMP
Assign sequence number:
Sequence No. (1-65535): Specify the sequence number. The value is from 1 to 65535.
Auto Assign: Auto assign the sequence number for a new rule.
Assign Rule Criteria: Specify the IPv4 ACL settings.
ToS: Check the box to specify the ToS priority and DSCP value.
ToS (0-7): Specify the ToS value.
DSCP (0-63): Specify the DSCP value. The values are between 0 and 63.
IPv4 Address: Specify the IPv4 Source and destination address.
Source: Select the source IP to be specified or Any relevant to the ACL rules. Enter a source IP address and
source IP mask. For example, to set 176.212.XX.XX, use mask 255.255.0.0.
Destination: Select the destination IP to be specified or Any relevant to the ACL rules. Enter a destination IP
address and destination IP mask. For example, to set 176.212.XX.XX, use mask 255.255.0.0.
Protocol: Check Protocol to configure the related settings.
Protocol Type: Select the protocol type for IPv4. The possible fields are ICMP, IGMP, TCP, UDP and
Protocol ID.
ICMP Type (0-255): Sets the ICMP Type field as an essential field to match.
Code (0-255): Sets the ICMP code field as an essential field to match.
Select the ports which added into the Access-List and click Next button then the ACL profile is added.
To define the IPv4 ACL IGMP Rule: Select IPv4 ACL with IGMP and click Next button. The updates to
show the follows:
74
Advertisement
Table of Contents
