Fault Codes - Fisher & Paykel WA8060E Installation Instructions Manual

When a continuous series of beeps is sounded, all the lights turn off on the control
panel and a number appears on the display, a fault has occurred. The washer will
automatically enter this mode if a fault occurs. The fault code will be displayed as a
number on the digital display. To stop the sound, touch any button and perform the
following steps:
Turn your washer off at the power point.
1
Wait 1 minute and turn it back on.
2
Remove your wash load.
3
Perform a 'Rinse' cycle.
4
If the washer will still not work you will be required to call a Fisher & Paykel Authorised
5
Repairer to arrange service (refer to the 'Customer Care' section). Record the fault
code number displayed and the serial number of your washer (located on the rear of
the washer) before calling. The fault code will indicate to the repairer what the problem
could potentially be.
If a fault code is being displayed, you can still turn your washer off by touching
'Power' .

FAULT CODES

45