Supplied Accessories; Attaching The Stand; Symbols Used In This Manual - Magnavox 19MF339B User Manual

Supplied Accessories

user manual
(1EMN24239)
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.

Attaching the Stand

You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
1
Spread a thick and soft cloth over a
table.
Place the main unit face down onto it.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by "
when you remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.

Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:
TV : Analog TV operation
• If neither symbol appears under the function heading, operation is applicable to both.
quick start guide remote control
(1EMN24541) (NF802UD)
2
Hang the hook under the bottom
of the main unit to the stand's hole
(shown arrow
stand in the direction of the screen
(shown arrow
Make sure not to put the AC power
cord between the stand and the
unit.
➂
". Pull up the stand in the direction of the rear of the unit. Be careful not to drop the stand
batteries
(AAA x 2)
3
➀
), then slide down the
➁
).
: Digital TV operation
DTV
Phillips pan screw for
attaching the stand x 3
(FPH34120)
Drive Phillips pan screws in the 3
threaded holes at the bottom of the
stand with a screwdriver tightly.
screw holes
5
EN