Programming A Non-Rolling Code - Dodge 2016 Dart Owner's Manual

Hide thumbs Also See for 2016 Dart:

Table of Contents

274 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Reprogramming A Single HomeLink Button

(Rolling Code)

To reprogram a channel that has been previously trained,

follow these steps:

1. Cycle the ignition to the ON/RUN position.

2. Push and hold the desired HomeLink button until the

indicator light begins to flash after 20 seconds. Do not

release the button.

3. Without releasing the button proceed with "Program-

ming A Rolling Code" step 2 and follow all remaining

Programming A Non-Rolling Code

For programming Garage Door Openers manufactured

before 1995.

1. Cycle the ignition to the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 inches (3 to 8

cm) away from the HomeLink button you would like

to program while keeping the HomeLink indicator

light in view.

3. Push and hold the HomeLink button you want to

program while you push and hold the hand-held

transmitter button.

4. Continue to hold both buttons and observe the indi-

cator light. HomeLink indicator will flash slowly and

then rapidly after HomeLink has received the fre-

quency signal from the hand-held transmitter. Release

both buttons after the indicator light changes from

slow to rapid.

5. Push and hold the programmed HomeLink button

and observe the indicator light.

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device should

activate when the HomeLink button is pressed.

Table of Contents