Baby Lock Ovation Accessories Manual page 8

Double Fold Bias
Binder
1-1/8 inch (28mm) (BLE8-S3)
1-1/2 inch (36mm) (BLE8-S2)
Instructions
This conventional binder will double fold and sew bias
strips to your project in one quick step, using either a chain
or coverstitch. Choose from two widths based on your
preference.
MACHINE SETTINGS
Stitch type: 1-1/2" Chain Stitch - C3 Needle Position C2-C3
Narrow Right Cover Stitch C2-C3
Stitch type: 1-1/8" Narrow Right Cover Stitch
Chain Stitch - C3 Needle
Stitch length: 3-4
Upper looper: Down
Upper knife: Disengaged "LOCKED"
Sewing table: On
Bias Strip Cut Size:
1-1/8 inch Binder:
• Cut 1-1/8 inch bias from fine fabrics such as calico, muslin,
etc.
• Cut 1 inch wide for medium weight fabrics such as trigger,
lightweight denim.
1-1/2 inch Binder:
• Cut 1-3/8 inch for fine fabrics such as calico, muslin, etc.
• Cut 1-1/4 inch wide for medium weight fabrics such as
trigger, lightweight denim.
Note: Test with fabric strip to make sure of correct width of
bias.
Note: When using BLCS-2 or BLCS the accessory adaptor
BLCS-AA is needed.
Instructions:
1. Secure attachment to table with guide fixing screws.
2. Cut fabric strips to size needed.
3. Raise presser foot. With the point of the bias strip,
place strip into attachment. Use tweezers to feed the
strip into the attachment.
4. Place the folded bias up to the needles and under
the presser foot.
5. Turn the handwheel 3-4 times to secure the stitching
in the fabric.
6. Place the fabric that is to be bound into the slot of
the attachment. Place in the folded bias in front of
the presser foot.
7. Loosen the guide fixing screws and move the
attachment right or left to align the attachment with
the needle position.
8. Sew test for proper alignment before sewing on
project.
www.babylock.com