Installing Batteries In The Remote Control; Using A Remote Control; The Vcr/Dvd Recorder Switching - Magnavox cmwR20v6 Owner's Manual

Dvd recorder with video cassette recorder
Table of Contents

Advertisement

Installing batteries in the remote control

Install two "AAA" size batteries (supplied) matching
the polarity indicated inside battery compartment of
the remote control.
1
2
Note:
Incorrect use of batteries can result in hazards
such as leakage and bursting. Please observe the
following:
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together,
although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of
each battery match the indications in the battery
compartment.
• Remove batteries from equipment that is not going
to be used for a month or more.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction's rules that apply in your country
or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.

The VCR/DVD recorder switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which component
you wish to operate with [SOURCE].
VCR MODE
Press [VCR] on the remote control.
(Verify that the VCR indicator is lit.)
DVD MODE
Press [DVD] on the remote control.
(Verify that the DVD indicator is lit.)
Note:
• Pressing only [SOURCE] on the front panel
DOES NOT switch the mode of the remote
control. You MUST select the correct mode on
the remote control.
• You cannot switch to another mode (DVD or
VCR) during in the timer-standby mode.
• Pressing [DVD REC I] or [VCR REC I] on the
remote control switches immediately its respective
mode so that you can start recording directly on
the appropriate media.
10
EN
Before you start
Functional overview (cont'd)
3
POWER ON
STANDBY-ON

Using a remote control

Keep in mind the following when using the remote
control:
• Make sure that there is no obstacle between the
remote control and the remote sensor on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the
remote sensor of the unit.
• Remote control for different devices can interfere
with each other. Avoid using remote control for
other equipment located close to the unit.
• Replace the batteries when you notice a fall off in
the operating range of the remote control.
• The maximum operable ranges from the unit are
as follows.
- Line of sight: approx. 3 feet (7m)
- Either side of the center:
approx. 16 feet (5m) within 30°
- Above: approx. 16 feet (5m) within 15°
- Below: approx. 10 feet (3m) within 30°
Within about
23 feet (7m)
30°
30°
Remote
control
OPEN/CLOSE
REW
F.FWD
STOP/EJECT
PLAY
RECORD
CHANNEL
D.DUBBING
VCR SOURCE DVD
IR
VCR SOURCE DVD
STOP
PLAY
RECORD
S-VIDEO
VIDEO
L
AUDIO
R
DVD button
VIDEO/TV
VCR
VCR button
.@/:
ABC
1
2
GHI
JKL
4
5
PQRS
TUV
8
7
CLEAR/C-RESET
SPACE
0
DVD indicator
RETURN
OK
SOURCE button
DISC MENU
VCR indicator
CHANNEL
TIMER
VCR REC DVD REC REC MODE
TIMER SET
SLOW
SEARCH
AUDIO DUBBING
STANDBY-ON
DVD
OPEN/CLOSE
DEF
3
MNO
6
WXYZ
9
TITLE
DISPLAY
SETUP
CM SKIP RAPID PLAY

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cmwr20v6

Table of Contents