Installing Batteries In The Remote Control; Using A Remote Control; The Vcr/Dvd Recorder Switching - Magnavox MWR20V6 Owner's Manual

Installing batteries in the remote control

Install two "AAA" size batteries (supplied) matching
the polarity indicated inside battery compartment of
the remote control.
1
2
Note:
Incorrect use of batteries can result in hazards
such as leakage and bursting. Please observe the
following:
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together,
although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of
each battery match the indications in the battery
compartment.
• Remove batteries from equipment that is not going
to be used for a month or more.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction's rules that apply in your country
or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.

The VCR/DVD recorder switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which component
you wish to operate with [SOURCE].
VCR MODE
Press [VCR] on the remote control.
(Verify that the VCR indicator is lit.)
DVD MODE
Press [DVD] on the remote control.
(Verify that the DVD indicator is lit.)
Note:
• Pressing only [SOURCE] on the front panel
DOES NOT switch the mode of the remote
control. You MUST select the correct mode on
the remote control.
• You cannot switch to another mode (DVD or
VCR) during in the timer-standby mode.
• Pressing [DVD REC I] or [VCR REC I] on the
remote control switches immediately its respective
mode so that you can start recording directly on
the appropriate media.
10 EN
Before you start
Functional overview (cont'd)
3
POWER ON
STANDBY-ON

Using a remote control

Keep in mind the following when using the remote
control:
• Make sure that there is no obstacle between the
remote control and the remote sensor on the unit.
• Remote operation may become unreliable if strong
sunlight or fluorescent light is shining on the
remote sensor of the unit.
• Remote control for different devices can interfere
with each other. Avoid using remote control for
other equipment located close to the unit.
• Replace the batteries when you notice a fall off in
the operating range of the remote control.
• The maximum operable ranges from the unit are
as follows.
- Line of sight: approx. 3 feet (7m)
- Either side of the center:
approx. 16 feet (5m) within 30°
- Above: approx. 16 feet (5m) within 15°
- Below: approx. 10 feet (3m) within 30°
Within about
23 feet (7m)
30°
30°
Remote
control
OPEN/CLOSE
REW F.FWD STOP/EJECT PLAY RECORD CHANNEL D.DUBBING VCR SOURCE DVD
IR
VCR SOURCE DVD
STOP PLAY RECORD
L AUDIO R
S-VIDEO VIDEO
DVD button
STANDBY-ON
VIDEO/TV VCR DVD
VCR button
.@/: ABC
1 2
GHI JKL
4
5
PQRS TUV
7 8
CLEAR/C-RESET SPACE
0
DVD indicator
RETURN
OK
SOURCE button
DISC MENU
VCR indicator
CHANNEL
TIMER VCR REC DVD REC REC MODE
TIMER SET SLOW CM SKIP RAPID PLAY
SEARCH AUDIO DUBBING
OPEN/CLOSE
DEF
3
MNO
6
WXYZ
9
TITLE
DISPLAY
SETUP